RADIO120.LMK - Revision history

Va7stv at 18:51, 8 October 2017

2017-10-08T18:51:46Z

← Older revision		Revision as of 18:51, 8 October 2017
Line 1:		Line 1:
	{{Template:HamWAN Site Bar\| backlink=[[Installation/LMK HamWAN Sector\|LMK HamWAN Sector]]}}		{{Template:HamWAN Site Bar\| backlink=[[Installation/LMK HamWAN Sector\|LMK HamWAN Sector]]}}

	~~'''DRAFT Configuration Untested 6/16/2017 by VA7STV'''~~

	<pre>		<pre>
	# ~~jan~~/06/~~1970 15~~:55:16 by RouterOS 6.35.1		# oct/08/2017 11:51:03 by RouterOS 6.40.4
	# software id = ~~3AI0~~-~~3ZMS~~		# software id = WU89-C7AA
	#		#
			# model = 912UAG-5HPnD
			# serial number = 725C045C0D28
	/interface bridge		/interface bridge
	add name=BRIDGE-HAMWAN-PRIVATE		add fast-forward=no name=BRIDGE-HAMWAN-PRIVATE
	add name=BRIDGE-HAMWAN-PUBLIC		add fast-forward=no name=BRIDGE-HAMWAN-PUBLIC
	/interface wireless		/interface wireless
	set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10mhz ~~disabled=no~~ frequency=5900 frequency-mode=superchannel mode=ap-bridge nv2-cell-radius=100 radio-name=\		set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10mhz \
	VA7DIG/LMK~~-RADIO120~~ rx-chains=0,1 ssid=HamWan tdma-period-size=4 tx-chains=0,1 wireless-protocol=nv2		frequency=5900 frequency-mode=superchannel ht-basic-mcs=mcs-0 \
			ht-supported-mcs=mcs-0 mode=ap-bridge nv2-cell-radius=100 radio-name=\
			VA7DIG/RADIO120.LMK rx-chains=0,1 ssid=HamWan tdma-period-size=4 \
			tx-chains=0,1 wireless-protocol=nv2
	/interface vlan		/interface vlan
	add interface=ether1 name=ETH1-HAMWAN-PRIVATE vlan-id=601		add interface=ether1 name=ETH1-HAMWAN-PRIVATE vlan-id=601
	add interface=ether1 name=ETH1-HAMWAN-PUBLIC vlan-id=600		add interface=ether1 name=ETH1-HAMWAN-PUBLIC vlan-id=600
	/interface wireless channels		/interface wireless channels
	add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" frequency=5920 list=HamWAN name=Sector1-5 width=5		add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" \
	add band=5ghz-onlyn comment="Cell sites radiate this at 120 degrees (south-east)" frequency=5900 list=HamWAN name=Sector2-5 width=5		frequency=5920 list=HamWAN name=Sector1-5 width=5
	add band=5ghz-onlyn comment="Cell sites radiate this at 240 degrees (south-west)" frequency=5880 list=HamWAN name=Sector3-5 width=5		add band=5ghz-onlyn comment=\
	add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" frequency=5920 list=HamWAN name=Sector1-10 width=10		"Cell sites radiate this at 120 degrees (south-east)" frequency=5900 \
	add band=5ghz-onlyn comment="Cell sites radiate this at 120 degrees (south-east)" frequency=5900 list=HamWAN name=Sector2-10 width=10		list=HamWAN name=Sector2-5 width=5
	add band=5ghz-onlyn comment="Cell sites radiate this at 240 degrees (south-west)" frequency=5880 list=HamWAN name=Sector3-10 width=10		add band=5ghz-onlyn comment=\
	add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" frequency=5920 list=HamWAN name=Sector1-5 width=5		"Cell sites radiate this at 240 degrees (south-west)" frequency=5880 \
			list=HamWAN name=Sector3-5 width=5
			add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" \
			frequency=5920 list=HamWAN name=Sector1-10 width=10
			add band=5ghz-onlyn comment=\
			"Cell sites radiate this at 120 degrees (south-east)" frequency=5900 \
			list=HamWAN name=Sector2-10 width=10
			add band=5ghz-onlyn comment=\
			"Cell sites radiate this at 240 degrees (south-west)" frequency=5880 \
			list=HamWAN name=Sector3-10 width=10
			add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" \
			frequency=5920 list=HamWAN name=Sector1-5 width=5
	/interface wireless security-profiles		/interface wireless security-profiles
	set [ find default=yes ] supplicant-identity=MikroTik		set [ find default=yes ] supplicant-identity=MikroTik
			/snmp community
			set [ find default=yes ] name=hamwan
	/interface bridge port		/interface bridge port
	~~add comment=defconf interface=ether1~~
	~~add bridge=BRIDGE-HAMWAN-PUBLIC comment=defconf interface=wlan1~~
	add bridge=BRIDGE-HAMWAN-PUBLIC interface=ETH1-HAMWAN-PUBLIC		add bridge=BRIDGE-HAMWAN-PUBLIC interface=ETH1-HAMWAN-PUBLIC
	add bridge=BRIDGE-HAMWAN-PRIVATE interface=ETH1-HAMWAN-PRIVATE		add bridge=BRIDGE-HAMWAN-PRIVATE interface=ETH1-HAMWAN-PRIVATE
			add bridge=BRIDGE-HAMWAN-PUBLIC comment=defconf interface=wlan1
	/ip address		/ip address
	add address=10.246.1.3/16 interface=BRIDGE-HAMWAN-PRIVATE network=10.246.0.0		add address=10.246.1.3/16 interface=BRIDGE-HAMWAN-PRIVATE network=10.246.0.0
			/ip dns
			set servers=8.8.8.8
			/ip route
			add distance=1 gateway=10.246.0.1
			/snmp
			set contact="#HamWAN on irc.freenode.org" enabled=yes location=\
			49.879452,-119.460493 trap-version=2
			/system clock
			set time-zone-name=America/Vancouver
	/system identity		/system identity
	set name=LMK~~-RADIO120~~		set name=RADIO120.LMK
	/system leds		/system leds
	set 0 interface=wlan1		set 0 interface=wlan1
	~~/system routerboard settings~~
	~~set cpu-frequency=600MHz init-delay=0s protected-routerboot=disabled~~

	</pre>		</pre>

Va7stv at 04:36, 27 June 2017

2017-06-27T04:36:48Z

← Older revision		Revision as of 04:36, 27 June 2017
Line 1:		Line 1:
			{{Template:HamWAN Site Bar\| backlink=[[Installation/LMK HamWAN Sector\|LMK HamWAN Sector]]}}

	'''DRAFT Configuration Untested 6/16/2017 by VA7STV'''		'''DRAFT Configuration Untested 6/16/2017 by VA7STV'''

Va7stv: Va7stv moved page Radio120.lmk to RADIO120.LMK

2017-06-23T16:45:22Z

Va7stv moved page Radio120.lmk to RADIO120.LMK

← Older revision	Revision as of 16:45, 23 June 2017
(No difference)

Va7stv at 17:58, 16 June 2017

2017-06-16T17:58:04Z

← Older revision		Revision as of 17:58, 16 June 2017
Line 9:		Line 9:
	add name=BRIDGE-HAMWAN-PUBLIC		add name=BRIDGE-HAMWAN-PUBLIC
	/interface wireless		/interface wireless
	set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10mhz disabled=no frequency=~~5920~~ frequency-mode=superchannel mode=ap-bridge nv2-cell-radius=100 radio-name=\		set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10mhz disabled=no frequency=5900 frequency-mode=superchannel mode=ap-bridge nv2-cell-radius=100 radio-name=\
	VA7DIG/LMK-~~RADIO0~~ rx-chains=0,1 ssid=HamWan tdma-period-size=4 tx-chains=0,1 wireless-protocol=nv2		VA7DIG/LMK-RADIO120 rx-chains=0,1 ssid=HamWan tdma-period-size=4 tx-chains=0,1 wireless-protocol=nv2
	/interface vlan		/interface vlan
	add interface=ether1 name=ETH1-HAMWAN-PRIVATE vlan-id=601		add interface=ether1 name=ETH1-HAMWAN-PRIVATE vlan-id=601

Va7stv: Created page with "'''DRAFT Configuration Untested 6/16/2017 by VA7STV'''

 # jan/06/1970 15:55:16 by RouterOS 6.35.1 # software id = 3AI0-3ZMS # /interface bridge add name=BRIDGE-HAMWAN-PR..."

2017-06-16T17:18:10Z

Created page with "'''DRAFT Configuration Untested 6/16/2017 by VA7STV''' <pre> # jan/06/1970 15:55:16 by RouterOS 6.35.1 # software id = 3AI0-3ZMS # /interface bridge add name=BRIDGE-HAMWAN-PR..."

New page

'''DRAFT Configuration Untested 6/16/2017 by VA7STV'''

<pre>
# jan/06/1970 15:55:16 by RouterOS 6.35.1
# software id = 3AI0-3ZMS
#
/interface bridge
add name=BRIDGE-HAMWAN-PRIVATE
add name=BRIDGE-HAMWAN-PUBLIC
/interface wireless
set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10mhz disabled=no frequency=5920 frequency-mode=superchannel mode=ap-bridge nv2-cell-radius=100 radio-name=\
VA7DIG/LMK-RADIO0 rx-chains=0,1 ssid=HamWan tdma-period-size=4 tx-chains=0,1 wireless-protocol=nv2
/interface vlan
add interface=ether1 name=ETH1-HAMWAN-PRIVATE vlan-id=601
add interface=ether1 name=ETH1-HAMWAN-PUBLIC vlan-id=600
/interface wireless channels
add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" frequency=5920 list=HamWAN name=Sector1-5 width=5
add band=5ghz-onlyn comment="Cell sites radiate this at 120 degrees (south-east)" frequency=5900 list=HamWAN name=Sector2-5 width=5
add band=5ghz-onlyn comment="Cell sites radiate this at 240 degrees (south-west)" frequency=5880 list=HamWAN name=Sector3-5 width=5
add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" frequency=5920 list=HamWAN name=Sector1-10 width=10
add band=5ghz-onlyn comment="Cell sites radiate this at 120 degrees (south-east)" frequency=5900 list=HamWAN name=Sector2-10 width=10
add band=5ghz-onlyn comment="Cell sites radiate this at 240 degrees (south-west)" frequency=5880 list=HamWAN name=Sector3-10 width=10
add band=5ghz-onlyn comment="Cell sites radiate this at 0 degrees (north)" frequency=5920 list=HamWAN name=Sector1-5 width=5
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTik
/interface bridge port
add comment=defconf interface=ether1
add bridge=BRIDGE-HAMWAN-PUBLIC comment=defconf interface=wlan1
add bridge=BRIDGE-HAMWAN-PUBLIC interface=ETH1-HAMWAN-PUBLIC
add bridge=BRIDGE-HAMWAN-PRIVATE interface=ETH1-HAMWAN-PRIVATE
/ip address
add address=10.246.1.3/16 interface=BRIDGE-HAMWAN-PRIVATE network=10.246.0.0
/system identity
set name=LMK-RADIO120
/system leds
set 0 interface=wlan1
/system routerboard settings
set cpu-frequency=600MHz init-delay=0s protected-routerboot=disabled

</pre>